Applying Variable Speed Drives to Control Pressure

Pressure Control Pump Station

Using variable speed drives (VSDs) to control pressure reduces the electrical energy requirements by reducing the amount of hydraulic energy actually produced.

A basic pressure control pump station is equipped with one pump controlled by one variable speed drive (VSD). In some pump stations, pumps connected in parallel are a more efficient solution. Several parallel pumps can be controlled with one VSD controlling the master pump and contactors switching the other pumps on and off.

Figure below shows a set-up parallel pumps using one drive to control three pumps.

System Redundancy

To guarantee pump operation, even when a fault occurs, the pump system needs redundancy. In pump stations this means that a failure of one pump, motor or drive in a parallel installation does not cause a process interruption but the operation will continue with a limited capacity.

In order to have a replacement for a failed unit, a parallel system is needed! This means that each pump is controlled by an ABB drive with intelligent pump control feature.

In a ring connection implemented with IPC communication link, it is possible to define the actions for the drives in the event of failure of the communication link in order to achieve 100% redundancy. No PLC is needed.

Figure below shows a system loop with three ABB drives in ring connection controlling three pumps.

Source : 

electrical-engineering-portal.com

ABB IPC Configuration Guide